11th Class Exercise 9.14
Aeroplane Wing Lift Simulation Aeroplane Wing Lift Simulation Wing Parameters Wing Area (m²) Value: 2.5 m² Air Density (kg/m³) Value: […]
11th Class Exercise 9.14 Read More »
11th Class Exercise 9.15
Fluid Flow Simulation Fluid Flow Simulation Inlet Width 60 px Constriction Width 20 px Flow Rate 5 units Show Pressure
11th Class Exercise 9.15 Read More »
11th Class Exercise 9.16
Spray Pump Flow Simulation Spray Pump Flow Simulation Tube Area (cm²): 8.0 cm² Hole Diameter (mm): 1.0 mm Number of
11th Class Exercise 9.16 Read More »
11th Class Exercise 9.17
Surface Tension Simulation Soap Film Surface Tension Simulation Weight (N): 1.5 × 10⁻² N Slider Length (cm): 30 cm Reset
11th Class Exercise 9.17 Read More »
11th Class Exercise 9.18
Liquid Film Surface Tension Simulation Liquid Film Surface Tension Simulation This simulation demonstrates how surface tension in liquid films can
11th Class Exercise 9.18 Read More »
11th Class Exercise 9.19
Mercury Drop Pressure Simulation Mercury Drop Pressure Simulation Visualize how surface tension affects pressure inside a mercury drop at room
11th Class Exercise 9.19 Read More »
11th Class Exercise 9.20
Bubble Pressure Simulation Bubble Pressure Simulation Visualizing pressure differences in soap bubbles and air bubbles within a liquid Bubble Radius
11th Class Exercise 9.20 Read More »
11th Class Exercise 8.1
Young’s Modulus Comparison: Steel vs Copper Young’s Modulus Comparison: Steel vs Copper This simulation demonstrates how steel and copper wires
11th Class Exercise 8.1 Read More »
11th Class Exercise 8.2
Stress-Strain Curve Simulation Stress-Strain Curve Simulation Material Type AluminumSteelCopperBrassRubber Young’s Modulus (E) = Stress / Strain (in elastic region) Yield
11th Class Exercise 8.2 Read More »
11th Class Exercise 8.3
Stress-Strain Graph Simulation Stress-Strain Graph Simulation Material A Material B Material A Stiffness: Low High Very High Material B Stiffness:
11th Class Exercise 8.3 Read More »
11th Class Exercise 8.4
Material Properties Simulation Material Properties Simulation This simulation demonstrates two key concepts in material science: Young’s Modulus: Comparing the stiffness
11th Class Exercise 8.4 Read More »
11th Class Exercise 8.5
Wire Elongation: Steel vs Brass Wire Elongation: Steel vs Brass Compare how steel and brass wires elongate under different loads.
11th Class Exercise 8.5 Read More »
11th Class Exercise 8.6
Aluminum Cube Shear Deformation Simulation Aluminum Cube Shear Deformation Simulation Cube Edge Length (cm) 5 cm 10 cm 20 cm
11th Class Exercise 8.6 Read More »
11th Class Exercise 8.7
Steel Column Compression Simulation Steel Column Compression Simulation Structure Mass (kg): 10,000 kg 50,000 kg 100,000 kg Inner Radius (cm):
11th Class Exercise 8.7 Read More »
11th Class Exercise 8.8
Copper Tensile Strain Simulation Copper Tensile Strain Simulation This simulation demonstrates elastic deformation in a copper piece under tension. Adjust
11th Class Exercise 8.8 Read More »